NEW TEXAS STAR DX-350HDV 2879 Pills CW AMPLIFIER Amp W/ NEW 33 Amp Power Supply

Description

Texas Star 350HDV and Delta DPS33 power supply!!
Listing is for 1 BRAND NEW UNUSED Texas Star DX350HDV CW amplifier with Two 2SC 2879 Transistors AND brand new Delta DPS33 33 amp ac/dc power supply!! All you need is your radio and you got your base station all setup!!
Unit is in absolutely excellent BRAND NEW UNUSED condition. All units are bench tested by our technician before shipping to assure our customers of 100% reliability and operation. FAST UPS ground shipping!!
Serious buyers only please. If your feedback is weak, please do not bother!
There are no returns or exchanges on this amplifier. There is no warranty on it and it is being sold AS IS (which is 100% working), check my feedback and you'll see we do not mess around.  If your questionable about whether your setup will work with this amplifier, then this is not the amp for you. People trying to take parts out of this amplifier will have to keep it moving to the next seller because its not going to happen with this.
Serious buyers only please. If your feedback is weak, please do not even bother. Thanks!
CW Transmitters
These transmitters are designed for mobile or base CW operation. Powered by the 12 volt vehicle battery or 12 volt regulated power supply, the maximum power output is less than 5 watts RMS. Frequency of operation is within the 10 meter band, determined by installation of a crystal into the oscillator board. The transmitters contain a transmit/receive relay and an output connector for the receiver to share the antenna and permit break-in operation.
OPERATION:
• Red "POWER" Button turns the unit on and off.
• White "REC AMP" Button turns the receive amplifier on to provide 6dB of gain for your receiver. This will work independently of the power button -- that is, the white button may be pressed "on" even when the red button is "off." The oscillator may be operated without any output to the antenna. You will be able to hear the signal in your receiver. This may be useful to adjust your electronic keyer or to practice your Morse Code "off the air."
• Green Button reduces power on all models. On models DX 400V and DX 500V, it also activates the RF Output Knob.
• "DELAY" Switch reduces power and adds delay to the transmit/receive relay to accommodate different transmission rates for break-in keying operation. On models DX 400V and DX 500V, this button adds delay but does not reduce power.
• RF Output Knob controls RF output level when the Green Button is engaged. On the DX 667V only, the RF Output knob is operational at all times.
• Meter is an RF Relative Output Indicator and lights during transmission.
• A Crystal made for series operation must be installed into the holes labeled "X-1" near the top of the oscillator board. The frequency should fall between 28.0 MHz and 29.7 MHz.
• Key Jack for 1/8" miniature phone plug is located on the rear of the unit for connection of the telegraph key.
• Power Cables are also located at the rear. The red lead connects to the positive side of the power supply, and the black lead connects to the negative side.
• Antenna Connector (SO239) for 50 ohm antenna is located on the rear.
• Radio Connector (SO239) for 50 ohm output to the receiver is also located on the rear.